Enterasys Networks ANG-1000 User Manual

Page 34

Aurorean Network Gateway-1000 User’s Guide

Chapter 3

Configuring the ANG-1000 with Aurorean Web Config

–

Enter the Gateway IP address.

–

Specify the Primary DNS IP address.

–

Set the Secondary DNS IP address.

–

Click Apply.

H Click the PPPoE assigned IP address radio button and perform

the following steps:

–

Specify a Username supplied by your cable/DSL provider.

–

Enter a Password.

–

Type the password again in the Confirm field.

–

Click Apply.

If you chose the Manual or PPPoE options, a window appears
detailing the reconfiguration changes and prompting you to reboot the
ANG-1000. Click Reboot Now.

After a few moments when an IP address has been received for the external
port, the Internet LED will turn on. If a static IP address was configured, the
Internet LED will shine immediately.

NOTE

If you press the reset button after you have configured your ANG-1000,

you will lose your entire configuration. Any settings you supplied must
then be re-entered. We strongly recommend that you do not use the reset
button unless you want the configuration to return to factory defaults.