Enterasys Networks ANG-1000 User Manual
Page 20
8
Aurorean Network Gateway-1000 User’s Guide
Connecting Power to the ANG-1000
Chapter 2
Installation
A switching power supply including a 6’ power cord and a 7’ electrical cord
with an attached power supply is supplied with each system. To connect
these items to an ANG-1000, perform the following steps:
1
Plug the power supply cord into the system’s power socket as shown
in Figure 8.
Figure 8 Connecting AC Power on the ANG-1000
2
Plug the correct end of the AC power cord into the power supply and
the other end into a grounded AC outlet or UPS as shown in Figure 9.
The front Power LED will light the moment you power up the unit.
Figure 9 Connecting the Power Cable to the Power Supply
NOTE
International customers may swap the electrical cord segment shipped
with the ANG-1000 for a cord that meets the proper standard for their
country. A custom cord can be inserted in the power supply.
Power supply cable
Power supply
AC power cord