Enterasys Networks ANG-1000 - Manual (Page 23)

Aurorean Network Gateway-1000 User’s Guide
11
3
Configuring the ANG-1000 with Configuring the ANG-1000 with Configuring the ANG-1000 with Configuring the ANG-1000 with
Aurorean Web Config Aurorean Web Config Aurorean Web Config Aurorean Web Config
To configure the ANG-1000, use the Internet browser on your computer and
connect to the server via the Web. During the Web session, you run the
Aurorean Web Config utility and configure the system. Figure 13 illustrates
the process.
Figure 13 Configuring the ANG-1000 via Aurorean Web Config
Before You Begin
Before you begin configuration with Web Config, review the following:
H Be sure the ANG-1000 is cabled correctly as described in “Connecting
an ANG-1000” in Chapter 2 of this manual.
H Ask your DSL or cable modem Internet provider and Network
Administrator for any IP addresses, work group, network browsing
or other information you may need to configure the ANG-1000
properly. Minimally, you will need:
– The IP address of the ANG-3000/7000 you will connect to for
setting up the VPN.
PC Desktop
Aurorean
Aurorean
Remotely Control ANG
Network
Gateway
Policy
Manager