Magnum Energy ME-RC Remote - Manual (Page 37)

©2013 Magnum Energy, Inc. 30
3.0 Setup
TECH
Press
Status...
01 Temperatures
Rotate to
Press to select
Rotate to
desired
display:
Options: BTS:, Tfmer:, FETs:, AGS:
Figure 3-16, TECH: 01 Temperatures Display
• TECH: 02 Revisions – Displays the revisions of the devices that are
connected to the Magnum network. Rotate the SELECT knob to scroll
through the revisions. The following devices display revisions (if
connected to the remote): inverter, remote, AGS, BMK, and router.
TECH
Press
Status...
02 Revisions
Rotate to
Press to select
Rotate to
desired
display:
Options: Inverter:, Remote:, AGS:, BMK:, Router:
Figure 3-17, TECH: 02 Revisions Display
Info: The BMK, AGS, and the remote accessories may display a
“0.0” revision. Either the accessory is not installed, there is no com-
munication because of a bad or miswired network cable, the device
is not powered, or the device is bad.
• TECH: 03 Inverter Model – This read only menu displays the model
number of the connected inverter.
TECH
Press
Status...
03 Inv Model
Rotate to
Press
Status...
Model: ####
Display shows
connected inverter:
Figure 3-18, TECH: 03 Inv Model Display
Info: When “Model: UNKNOWN” is displayed, the remote is unable
to determine the inverter model. This happens when the remote is
connected to a later/newer inverter model not recognized by an older
remote. All remote menu selections and features that are available
in the inverter will function normally.
Info: The revision may display “0.0” for several reasons. Either the
inverter is not installed, there is no communication due to a bad or
miswired network cable, or the inverter is not powered or is bad.