Magnum Energy ME-RC Remote - Manual (Page 11)

©2013 Magnum Energy, Inc. 4
2.0 Installation
Figure 2-3, ME-RC Remote Dimensions
2.3 ME-RC Remote Dimensions
Use the information below (Figures 2-3 and 2-4) in preparation for mounting
the ME-RC remote. Directions for mounting follow in Section 2.4.
5 ¼” (13.3 cm)
3 ¼” (8.3 cm)
5 ⅞" (14.9 cm)
3
⅞
" (9.8 cm)
2 ¾" (7.0 cm)
1 ½ "
(3.8 cm)
.9"
(2.3 cm)
1 ⅛"
(2.9 cm)
~1"
(2.5 cm)
~1 ⅝"
(4.1 cm)
2.4 Mounting the ME-RC Remote
The ME-RC can be fl ush mounted through an opening in the wall. Find a
location that is clean, dry and protected. Allow room to access the remote’s
SELECT knob and to view the LEDs/display.
CAUTION: Ensure that no AC power is connected to the inverter,
and then according your inverter owner’s manual correctly connect
the inverter to the batteries.
CAUTION: Always check for hidden electrical wires, pipes and
cables BEFORE drilling, cutting, or screwing into walls or cabinets.
Info: The ME-RC can be surface mounted on a wall using the op-
tional ME-BZ (remote bezel).