Magnum Energy Magnum Panel (MP Series) - Manual (Page 76)

© 2011 Magnum Energy, Inc. Page 69
4.0 Wiring Diagrams
Figure 4-1, Inverter AC Input and Output Wiring Diagram - MS4024
MS4024 Series Inverter –
showing AC wires from the
internal AC wiring terminal
3 0
Left side view of
inverter mounted
on MP Enclosure
Inverter AC
Input Wires
(Leg 1 Only)
Inverter AC
Output Wires
(Leg 1 Only)
AC
GROUND
AC HOT 2 OUT
AC NEUT IN
AC NEUT OUT
AC HOT 1 OUT
AC HOT 1 IN
AC HOT 2 IN
.
B
L
AC
K
.
W
HIT
E
.
B
L
AC
K w
/S
T
RIP
E
.
W
HIT
E
w
/S
T
RIP
E
.
G
R
E
E
N
Info: When wiring the MS4024 (or any other MS Series inverter), both the inverter input
and output neutral wires must be connected to a AC NEUTRAL busbar inside the MP
enclosure. This is because — depending on the inverter’s operating mode — the inverter’s
input and output neutral terminals may not be connected together (i.e., inverter’s
neutrals are not connected when “inverting”, and are combined when “charging”).
Note: Because a neutral to ground connection is also made in the MP enclosure, the neutral to
ground connection inside the MS4024 must be disconnected. Refer to the MS4024 owner’s manual
for information on how this is done.
See Note
Below