Magnum Energy Magnum Panel (MP Series) - Manual (Page 39)

Page 32 © 2011 Magnum Energy, Inc.
3.0 Installation
Figure 3-15c, Mounting Inverter Hood - MP Single Enclosure
Figure 3-15b, Mounting Inverter - MP Single Enclosure
Note: Prior to
mounting the inverter,
connect and separate
the AC input and
output wires within the
inverter, and then route
the wiring through the
MP enclosure. Ensure
the AC access plate
is reattached to the
inverter.
BP-S
(S
INGLE
M
OUNTING
B
ACKPLATE
)
MP S
INGLE
E
NCLOSURE
M
AGNUM
I
NVERTER
I
NVERTER
H
OOD
MP S
INGLE
E
NCLOSURE
BP-S
(S
INGLE
M
OUNTING
B
ACKPLATE
)
M
AGNUM
I
NVERTER
Note: The inverter hood does not
mount to the inverter chassis, it
must be mounted to a backplate or
wall. Mounting bolts for the hood
are included with the backplate,
otherwise the installer must supply
the bolts. The mounting slots on the
hood will accept up to a maximum
1/4” screw/bolt. The bottom edge
of the hood must be mounted fl ush
against the top of the inverter.
This is the optimal position for
minimizing the risk of objects falling
into the inverter, and at the same
time providing the airfl ow clearance
needed from the inverter’s top vents.