beautypg.com

0 maintenance and troubleshooting, 1 recommended inverter and battery care, 2 storage for mobile installations – Magnum Energy MS Series User Manual

Page 61

background image

Page 52

©

2012 Magnum Energy, Inc.

Maintenance and Troubleshooting

4.0 Maintenance and Troubleshooting

The following information is provided to help you keep your MS Series inverter/charger in optimum

operational condition.

4.1 Recommended Inverter and Battery Care

The MS Series inverter/charger is designed to provide you with years of trouble-free service. Even

though there are no user-serviceable parts, it is recommended that every 6 months you perform the

following maintenance steps to ensure optimum performance and extend the life of your batteries.

WARNING: Prior to performing any checks, switch OFF both the AC and DC circuits.

• Visually inspect the batteries for cracks, leaks, or swelling – replace if necessary
• Use baking soda to clean and remove any electrolyte spills or buildups
• Check and tighten all battery hold-down clamps (if applicable)
• Clean and tighten all battery terminals and connecting cables [10 to 12 ft lbf (13.6 to 16.3

N-m)]

• Check

and

fi ll battery water levels (liquid lead acid batteries only)

• Check individual battery voltages (load test those that have a voltage difference of more

than 0.3 VDC from each other) – replace if necessary

• Check all cable runs for signs of chafi ng – replace if necessary
• Check the inverter’s cooling vents – clean as necessary
• Check and tighten the inverter’s internal AC terminal block connections [16 in lbf (1.8

N-m)]

4.2 Storage for Mobile Installations

When placing the RV, boat or truck into storage, it is recommended that you perform the following

to ensure the system is properly shut down (or properly confi gured for storage). This is especially

important for maintaining the batteries.

• Perform the recommended maintenance steps listed in Section 4.1.
• Fully charge the batteries.
• Connect AC power (if available) and verify that the breaker to the inverter’s input is

switched ON (to allow battery charging).

• Verify the inverter is switched OFF.
• Switch OFF all unnecessary AC and DC loads.
• Disable the AGS (if installed) when the RV, boat, or truck is in a confi ned storage area.

WARNING: If an AGS were to start and run the generator for an extended period

of time in a confi ned area, a potentially fatal level of CO (Carbon Monoxide) could

accumulate.

This manual is related to the following products: