Magnum Energy MM-AE Series - Manual (Page 9)

©
2010 Magnum Energy, Inc.
2 1
3
4
6
5
8 7
Figure 2, Top Side Features
Standard Features and Benefi ts
The MM-AE Series inverter/charger converts 12 or 24 volts (de-
pending on model) direct current (VDC) power from your battery to
120 volts alternating current (VAC) power. The multi-stage battery
charger optimizes incoming AC power using Power Factor Correction
(PFC) technology to keep the inverter’s battery bank fully charged.
This inverter is designed to allow easy installation and use, and with
its die-cast aluminum baseplate it ensures maximum durability and
cooler more effi cient operation.
The inverter/charger provides the following:
• 600 or 1500 watts continuous (depending on model) at 25°C.
• Numerous protection features to provide a safe and
peace-of-mind operation.
• AC transfer switch circuitry; allowing incoming AC power to
continue to pass-thru to power loads even if the inverter is off.
• Dead battery charging for batteries that are extremely low.
• Automatic 4-stage battery charger with power factor correction
and temperature compensation – for optimum battery charging
(using the temperature sensor).
• Modern and aesthetically pleasing design with large AC wiring
compartment (provides easy access to AC wiring for simple and
quick connections) and 360° DC connection terminals with color
coded insulating covers.
• True RMS output voltage regulation to ensure the inverter will
deliver the correct amount of power – within the DC input volt-
age range and the continuous output power level.
• Quick connection accessory and remote ports – easily accepts
several optional remote controls and the Battery Temperature
Sensor.
1.0 Introduction
3