Yaskawa VS-616G5 Series Revision F Programming Manual - Manual (Page 89)

VS-616G5 Programming Manual 89
· During Run (setting: “0”)
Closes when a run command is input, or when the inverter outputs voltage.
· Zero-speed (setting: “1”)
Closes when the inverter output frequency is less than the minimum output frequency (El-09) during
V/f control with PG feedback. Closes when the motor speed is less than the zero-speed level (B2-01)
during flux vector control.
5 Frequency detection 2 √ √ √ √
6 Inverter ready √ √ √ √
7 DC bus undervoltage √ √ √ √
8 Baseblock 1 √ √ √ √
9 Option reference √ √ √ √
A Remote operation √ √ √ √
B Torque detection 1 (N.O.) √ √ √ √
C Loss of reference √ √ √ √
D DB overheat √ √ √ √
E Fault √ √ √ √
F Not used − − − −
10 Minor fault √ √ √ √
11 Reset command active √ √ √ √
12 Timer output √ √ √ √
13 Frequency agree 2 √ √ √ √
14 Desired frequency agree 2 √ √ √ √
15 Frequency detection 3 √ √ √ √
16 Frequency detection 4 √ √ √ √
17 Torque detection 1 (N.C.) √ √ √ √
18 Torque detection 2 (N.O.) √ √ √ √
19 Torque detection 2 (N.C.) √ √ √ √
1A Reverse direction √ √ √ √
1B Baseblock 2 √ √ √ √
1C Motor 2 Selection √ √ √ √
1D Regenerating − − − √
1E Restart enabled √ √ √ √
1F Overload (OL1) √ √ √ √
20 OH pre-alarm √ √ √ √
30 Current/torque limit − − √ √
31 Speed limit − − − √
33 Zero servo completion − − − √
37 During run 2 √ √ √ √
H2-01
to 3
Setting
Function
Control Method (A1-02)
Reference
Page V/f V/f w/ PG
Open Loop
Vector
Flux Vector
Section H: Control Circuit Terminals
H2 Digital Outputs