HEIDENHAIN TNC 620 (73498x-01) - Manual (Page 532)

532
Calling the file manager while the CYCLE
DEF
and TOUCH PROBE menus are active
Terminates the editing process and calls
the file manager. The respective soft-
key row remains selected when the file
manager is exited Error message Key non-functional
Calling the file manager while
CYCL CALL
, SPEC FCT, PGM CALL and
APPR/DEP menus are active
Terminates the editing process and calls
the file manager. The respective soft-
key row remains selected when the file
manager is exited Terminates the editing process and calls
the file manager. The basic soft-key row
is selected when the file manager is
exited
Datum table:
„ Sorting function by values within an
axis „ Available „ Not available
„ Resetting the table „ Available „ Not available
„ Hiding axes that are not present „ Not available „ Available
„ Switching the list/form view „ Switchover via split-screen key „ Switchover by toggle soft key
„ Inserting individual line „ Allowed everywhere, renumbering
possible after request. Empty line is
inserted, must be filled with zeros
manually „ Only allowed at end of table. Line with
value 0 in all columns is inserted
„ Transfer of actual position values in
individual axis to the datum table per
keystroke „ Not available „ Available
„ Transfer of actual position values in all
active axes to the datum table per
keystroke „ Not available „ Available
„ Using a key to capture the last
positions measured by TS „ Not available „ Available
„ Entry of comment in DOC column „ With the "Edit the current field"
function and the on-line keyboard „ Via ASCII keyboard
FK free contour programming:
„ Programming of parallel axes „ With X/Y coordinates, independent of
machine type; switchover with
FUNCTION PARAXMODE „ Machine-dependent with the existing
parallel axes
„ Automatic correction of relative
references „ Relative references in contour
subprograms are not corrected
automatically „ All relative references are corrected
automatically
Function TNC 620 iTNC 530