HEIDENHAIN TNC 620 (73498x-01) - Manual (Page 416)

416 Manual operation and setup
13.5 Using 3-D t
ouc
h pr
obes (T
ouc
h
P
robe F
u
nction sof
tw
a
re
option)
13.5 Using 3-D touch probes
(Touch Probe Function software
option)
Overview
The following touch probe cycles are available in the Manual Operation
mode:
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
If you use probing functions in a tilted working plane, you
must set 3-D ROT to Active for the Manual Operation and
Automatic operating modes.
Function Soft key Page
Calibrating the effective length Page 420
Calibrating the effective radius Page 421
Measuring a basic rotation using a line Page 424
Setting the datum in any axis Page 425
Setting a corner as datum Page 426
Setting a circle center as datum Page 427
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table, refer to
the User’s Manual for Cycle Programming.