HEIDENHAIN TNC 620 (73498x-01) - Manual (Page 505)

HEIDENHAIN TNC 620 505
1
7.3 T
e
c
hnical inf
o
rm
ation
Data interfaces „ One each RS-232-C /V.24 max. 115 kilobaud
„ Expanded data interface with LSV-2 protocol for remote operation of the TNC through
the data interface with the HEIDENHAIN software TNCremo
„ Ethernet interface 100BaseT
Approx. 40 to 80 megabaud (depending on file type and network load)
„ 3 x USB 2.0
Ambient temperature „ Operation: 0 °C to +45 °C
„ Storage: –30 °C to +70 °C
Accessories
Electronic handwheels „ One HR 410 portable handwheel, or
„ One HR 130 panel-mounted handwheel, or
„ Up to three HR 150 panel-mounted handwheels via HRA 110 handwheel adapter
Touch probes „ TS 220: 3-D touch trigger probe with cable connection, or
„ TS 440: 3-D touch trigger probe with infrared transmission
„ TS 444: Battery-free 3-D touch trigger probe with infrared transmission
„ TS 640: 3-D touch trigger probe with infrared transmission
„ TS 740: High-precision 3-D touch trigger probe with infrared transmission
„ TT 140: 3-D touch trigger probe for tool measurement
Software option 1 (option number 08)
Rotary table machining ‹ Programming of cylindrical contours as if in two axes
‹ Feed rate in mm/min
Coordinate transformation ‹ Tilting the working plane
Interpolation ‹ Circle in 3 axes with tilted working plane
Software option 2 (option number 09)
3-D machining ‹ 3-D tool compensation through surface normal vectors
‹ Keeping the tool normal to the contour
‹ Tool radius compensation normal to the tool direction
Interpolation ‹ Linear in 5 axes (subject to export permit)
Touch probe function (option number 17)
Touch-probe cycles ‹ Compensation of tool misalignment in manual mode
‹ Compensation of tool misalignment in automatic mode (Cycles 400 to 405)
‹ Datum setting in manual mode
‹ Datum setting in automatic mode (Cycles 410 to 419)
‹ Automatic workpiece measurement (Cycles 420 to 427, 430, 431, 0, 1)
‹ Automatic tool measurement (Cycles 480 to 483)
Specifications