HEIDENHAIN TNC 620 (73498x-01) - Manual (Page 466)

466 Test run and program run
15.5 Pr
ogr
am r
u
n U To select block scan, press the BLOCK SCAN soft key,
or
U Start-up at N: Enter the block number N at which the
block scan should end
U Program: Enter the name of the program containing
block N
U Repetitions: If block N is located in a program section
repeat or in a subprogram that is to be run repeatedly,
enter the number of repetitions to be calculated in the
block scan
U To start the block scan, press the machine START
button
U Contour approach (see following section)
Entering a program with the GOTO key
If you use the GOTO block number key for going into a
program, neither the TNC nor the PLC will execute any
functions that ensure a safe start.
If you use the GOTO block number key for going into a
subprogram,
„ the TNC will skip the end of the subprogram (LBL 0)
„ the TNC will reset function M126 (Shorter-path traverse
of rotary axes)
In such cases you must always use the mid-program
startup function.