HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 276)

276 Cycles: Coordinate Transformations
1
1
.1 F
undamentals
11.1 Fundamentals
Overview
Once a contour has been programmed, you can position it on the
workpiece at various locations and in different sizes through the use
of coordinate transformations. The TNC provides the following
coordinate transformation cycles:
Effect of coordinate transformations
Beginning of effect: A coordinate transformation becomes effective as
soon as it is defined—it is not called. It remains in effect until it is
changed or canceled.
To cancel coordinate transformations:
„ Define cycles for basic behavior with a new value, such as scaling
factor 1.0
„ Execute a miscellaneous function M2, M30, or an END PGM block
(depending on MP7300)
„ Select a new program
„ Program miscellaneous function M142 "Erasing modal program
information"
Cycle Soft key Page
7 DATUM SHIFT
For shifting contours directly within the
program or from datum tables Page 277
247 DATUM SETTING
Datum setting during program run Page 284
8 MIRROR IMAGE
Mirroring contours Page 285
10 ROTATION
For rotating contours in the working
plane Page 287
11 SCALING FACTOR
For increasing or reducing the size of
contours Page 289
26 AXIS-SPECIFIC SCALING FACTOR
For increasing or reducing the size of
contours with scaling factors for each
axis Page 291
19 WORKING PLANE
Machining in tilted coordinate system on
machines with swivel heads and/or
rotary tables Page 293