HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 254)

254 Fixed Cycles: Contour Pocket with Contour Formula
9.2 SL Cy
cles with Simple Cont
our F
o
rm
ula
Characteristics of the fixed cycles
„ The TNC automatically positions the tool to the set-up clearance
before a cycle.
„ Each level of infeed depth is milled without interruptions since the
cutter traverses around islands instead of over them.
„ The radius of “inside corners” can be programmed—the tool keeps
moving to prevent surface blemishes at inside corners (this applies
for the outermost pass in the Rough-out and Side Finishing cycles).
„ The contour is approached on a tangential arc for side finishing.
„ For floor finishing, the tool again approaches the workpiece on a
tangential arc (for tool axis Z, for example, the arc may be in the Z/X
plane).
„ The contour is machined throughout in either climb or up-cut milling.
The machining data (such as milling depth, finishing allowance and
set-up clearance) are entered as CONTOUR DATA in Cycle 20.
With Machine Parameter 7420 you can determine where
the tool is positioned at the end of Cycles 21 to 24.