HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 215)

HEIDENHAIN iTNC 530 215
7.
12 THREE-D CONT
OUR TRAIN (Cy
c
le 27
6, DIN/ISO: G27
6
)
Cycle parameters
U Milling depth Q1 (incremental): Distance between
workpiece surface and contour floor. If milling depth
Q1 = 0 and plunging depth Q10 = 0 are programmed,
the TNC machines the contour according to the Z
values defined in the contour subprogram. Input
range -99999.9999 to 99999.9999
U Finishing allowance for side Q3 (incremental):
Finishing allowance in the working plane. Input range
-99999.9999 to 99999.9999
U Clearance height Q7 (absolute): Absolute height at
which the tool cannot collide with the workpiece.
Position for tool retraction at the end of the cycle.
Input range -99999.9999 to 99999.9999; alternatively
PREDEF
U Plunging depth Q10 (incremental): Infeed per cut.
Effective only when the milling depth Q1 is defined as
not equal to 0. Input range -99999.9999 to
99999.9999
U Feed rate for plunging Q11: Traversing speed of the
tool in the spindle axis. Input range 0 to 99999.9999;
alternatively FAUTO, FU, FZ
U Feed rate for milling Q12: Traversing speed of the
tool in the working plane. Input range 0 to
99999.9999; alternatively FAUTO, FU, FZ
U Climb or up-cut? Up-cut = –1 Q15:
Climb milling: Input value = +1
Up-cut milling: Input value = –1
To enable climb milling and up-cut milling alternately
in several infeeds:Input value = 0
Example: NC blocks
62 CYCL DEF 276 THREE-D CONTOUR TRAIN
Q1=-20 ;MILLING DEPTH
Q3=+0 ;ALLOWANCE FOR SIDE
Q7=+50 ;CLEARANCE HEIGHT
Q10=+5 ;PLUNGING DEPTH
Q11=100 ;FEED RATE FOR PLNGNG
Q12=350 ;FEED RATE FOR MILLING
Q15=-1 ;CLIMB OR UP-CUT