HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 24)

24
4.1 Fundamentals ..... 108
Overview ..... 108
4.2 TAPPING NEW with a Floating Tap Holder (Cycle 206, DIN/ISO: G206) ..... 109
Cycle run ..... 109
Please note while programming: ..... 109
Cycle parameters ..... 110
4.3 RIGID TAPPING without a Floating Tap Holder NEW (Cycle 207, DIN/ISO: G207) ..... 111
Cycle run ..... 111
Please note while programming: ..... 112
Cycle parameters ..... 113
4.4 TAPPING WITH CHIP BREAKING (Cycle 209, DIN/ISO: G209) ..... 114
Cycle run ..... 114
Please note while programming: ..... 115
Cycle parameters ..... 116
4.5 Fundamentals of Thread Milling ..... 117
Prerequisites ..... 117
4.6 THREAD MILLING (Cycle 262, DIN/ISO: G262) ..... 119
Cycle run ..... 119
Please note while programming: ..... 120
Cycle parameters ..... 121
4.7 THREAD MILLING/ COUNTERSINKING (Cycle 263, DIN/ISO: G263) ..... 122
Cycle run ..... 122
Please note while programming: ..... 123
Cycle parameters ..... 124
4.8 THREAD DRILLING/MILLING (Cycle 264, DIN/ISO: G264) ..... 126
Cycle run ..... 126
Please note while programming: ..... 127
Cycle parameters ..... 128
4.9 HELICAL THREAD DRILLING/MILLING (Cycle 265, DIN/ISO: G265) ..... 130
Cycle run ..... 130
Please note while programming: ..... 131
Cycle parameters ..... 132
4.10 OUTSIDE THREAD MILLING (Cycle 267, DIN/ISO: G267) ..... 134
Cycle run ..... 134
Please note while programming: ..... 135
Cycle parameters ..... 136
4.11 Programming Examples ..... 138
4 Fixed Cycles: Tapping / Thread Milling ..... 107