HEIDENHAIN iTNC 530 (340 49x-06) - Manual (Page 49)

HEIDENHAIN iTNC 530 49
14.1 Switch-On, Switch-Off ..... 522
Switch-on ..... 522
Switch-off ..... 525
14.2 Moving the Machine Axes ..... 526
Note ..... 526
Moving the axis using the machine axis direction buttons ..... 526
Incremental jog positioning ..... 527
Traversing with electronic handwheels ..... 528
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 538
Function ..... 538
Entering values ..... 538
Changing the spindle speed and feed rate ..... 539
14.4 Datum Setting without a 3-D Touch Probe ..... 540
Note ..... 540
Preparation ..... 540
Workpiece presetting with axis keys ..... 541
Datum management with the preset table ..... 542
14.5 Using the 3-D Touch Probe ..... 549
Overview ..... 549
Selecting probe cycles ..... 549
Recording measured values from the touch-probe cycles ..... 550
Writing the measured values from touch probe cycles in datum tables ..... 551
Writing the measured values from touch probe cycles in the preset table ..... 552
Storing measured values in the pallet preset table ..... 553
14.6 Calibrating a 3-D Touch Probe ..... 554
Introduction ..... 554
Calibrating the effective length ..... 554
Calibrating the effective radius and compensating center misalignment ..... 555
Displaying calibration values ..... 556
Managing more than one block of calibrating data ..... 556
14.7 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 557
Introduction ..... 557
Basic rotation using 2 points: ..... 559
Determining basic rotation using 2 holes/studs: ..... 561
Workpiece alignment using 2 points ..... 562
14 Manual Operation and Setup ..... 521