HEIDENHAIN iTNC 530 (340 49x-06) - Manual (Page 19)

New functions 340 49x
-06
HEIDENHAIN iTNC 530 19
New functions 340 49x-06
„ The new HR 510, HR 520 and HR 550 FS handwheels are supported
(see “Traversing with electronic handwheels” on page 528)
„ New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks, see "3-D tool radius compensation depending on
the tool’s contact angle (3D-ToolComp software option)", page 494)
„ 3-D line graphics is now also possible in full-screen mode (see “3-D
Line Graphics (FCL2 Function)” on page 152)
„ A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see “Calling any
program as a subprogram” on page 280)
„ DCM: Saving and restoring of fixture situations
„ DCM: The form for test program generation now also contains icons
and tooltips (see “Check the position of the measured fixture” on
page 394)
„ DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
„ DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired.(see “Operating
FixtureWizard” on page 391)
„ DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
„ DCM: A library with standard chucking equipment is available now
(see “Fixture templates” on page 390)
„ DCM: Tool carrier management (see “Tool Holder Management
(DCM Software Option)” on page 398)