2 t ool d a ta – HEIDENHAIN iTNC 530 (340 49x-06) User Manual
Page 179

HEIDENHAIN iTNC 530
179
5.2 T
ool D
a
ta
Leaving the tool table
U
Call the file manager and select a file of a different type, such as a
part program
Additional notes on tool tables
MP7266.x defines which data can be entered in the tool table and in
which sequence the data is displayed.
Move to end of line
Copy highlighted field
Insert copied field
Add the entered number of lines (tools) at the
end of the table
Insert a line for the indexed tool number after the
active line. The function is only active if you are
permitted to store multiple compensation data
for a tool (MP7262 not equal to 0). The TNC
inserts a copy of the tool data after the last
available index and increases the index by 1.
Application: e.g. stepped drill with more than one
length compensation value
Delete current line (tool), the TNC will then delete
the content of the line in the table. If the tool to
be deleted has been entered in the pocket table,
the behavior of this function depends on MP
7263, (see “List of general user parameters” on
page 661)
Display / Do not display pocket numbers
Display all tools / only those tools that are stored
in the pocket table
You can overwrite individual columns or lines of a tool
table with the contents of another file. Prerequisites:
The target file must exist
The file to be copied must contain only the columns (or
lines) you want to replace
To copy individual columns or lines, press the REPLACE
FIELDS soft key (see “Copying a single file” on page 128).
Editing functions for tool tables
Soft key