HEIDENHAIN TNC 310 (286 140) Pilot - Manual (Page 58)

5 8
Graphics and Status Displays
Test Graphics
In the test run mode the TNC can graphically simulate the machining
process. The following display types are available via soft key:
Plan view
Projection in three planes
3D view
Status Displays
Select a screen layout showing the status information that
you need.
In the lower part of the screen in the program run modes the TNC
shows information on
• tool positions
• feed rate
• active miscellaneous functions
Additional status information can be called with the following
soft keys:
Program
information
Tool positions
Tool data
Coordinate
transformations