2 5 subprograms – HEIDENHAIN TNC 310 (286 140) Pilot User Manual
Page 25
2 5
Subprograms
S
= Jump;
R
= Return jump
Subprograms and Program Section
R e p e a t s
Subprograms and program section repeats enable you to program a
machining sequence once and then run it as often as needed.
Working with Subprograms
1
The main program runs up to the subprogram call CALL LBL1.
2
The subprogram labeled with LBL1 runs through to its end
(LBL0).
3
The main program resumes.
It's good practice to place subprograms after the end of the main
program (M2).
Answer the dialog prompt REP with the NOENT key.
You cannot call LBL0.
Working with Program Section Repeats
1
The main program runs up to the call for a section repeat
CALL LBL1 REP2/2.
2
The program section between LBL1 and CALL LBL1 REP2/2 is
repeated the number of times indicated with REP.
3
After the last repetition the main program resumes.
Altogether, the program section is run once more than the
number of programmed repeats.