HEIDENHAIN TNC 310 (286 140) Pilot - Manual (Page 29)

2 9
W
orking with C
y
cles
Calling a Cycle
The following cycles are effective as soon as they are defined:
• Cycles for coordinate transformations
• DWELL TIME cycle
• The SL cycle CONTOUR GEOMETRY
• Point patterns
All other cycles go into effect when they are called through
• CYCL CALL: effective for one block
• M99: effective for one block
• M89: effective until canceled (depends on machine parameter
settings)
Graphically assisted cycle programming
Select the PGM+FIGURE screen layout.
A graphic illustrates the input parameters for cycle definition.
Cycles for Coordinate Transformations
7 DATUM SHIFT Page 51
8 MIRROR IMAGE Page 52
10 ROTATION Page 53
11 SCALING FACTOR Page 54
Special Cycles
9 DWELL TIME Page 55
12 PGM CALL Page 55
13 ORIENTED SPINDLE STOP Page 56