HEIDENHAIN ND 1200 - Manual (Page 78)

78 2 Installation and Specifications
2.2 Har
dw
a
re
Installation
2.2 Hardware Installation
The ND 1200 is easy to install in a variety of measurement
applications. This section describes how to install the ND 1200
hardware.
Assembling the mounting stand
The ND 1200 is secured to the swivel slots of the mounting stand by
a shoulder screw, a cap screw and associated washers.
Assemble the ND 1200 to the mounting stand as shown, and then
tighten the cap screw (5) and washers (3 & 4) so that the ND 1200 will
be secure when adjusted to the desired tilt position.
U Tighten the shoulder screw (1).
U Tighten the cap screw (5) and washers (3 & 4) so that the ND 1200
will be secure when adjusted to the desired tilt position.
U Adjust the ND 1200 to the desired tilt position.
Benchtop location and mounting
Rest the ND 1200 on a flat, stable surface, or bolt it to a stable surface
from the bottom using four 10/32 screws fastened in the pattern
shown at the right.
The dimensions are shown in millimeters.
Mounting stand assembly
Mounting hole pattern