HEIDENHAIN ND 1200 - Manual (Page 72)

72 1 Operation
1
.9 Repor
ting
1.9 Reporting
Reporting
Reports of measurement results can be sent to a USB printer or USB
flash drive over the USB port, or to a PC over the RS-232 serial port.
Report types include:
Sending reports
Reports can be sent at any time. To send a report:
U Press the feature SEND key.
Reports can also be sent:
„ By including the send function in a program
„ When the Print setup screen is configured to send when an edge is
recognized
„ When the Measure setup screen is configured to send in response
to tolerance test results
„ By pressing a hot key configured in the Hot Keys setup screen to
send
Report content, destination and format are specified in the
Print, RS-232 and USB setup screens discussed in Chapter
2: Installation and Specifications.
Report type Report content
Display The data displayed on the DRO screen is sent as
one row for each axis.
Report All feature measurement data is sent in tabular
form without tolerance data.
Tol Rpt All tolerance data is sent in tabular form. Feature
measurement data are not sent.
CSV All feature measurement data is sent in as comma
separated variables without tolerance data.
Tab All feature measurement data is sent in as tab
separated variables without tolerance data.
None No data are sent.