HEIDENHAIN ND 1200 - Manual (Page 115)

ND 1200 QUADRA-CHEK 115
2.3 Sof
tw
a
re
set
u
p Display formatting
The Display screen contains data and choice fields for configuring
display resolution and other display parameters.
Display screen
The Display screen configuration fields include:
„ Resolutions for linear and angular measurements
„ Startup linear and angular units of measure
„ Selection of a comma or decimal point radix
„ Unit of angular measurement for the current session
„ Angular display resolutions for the Q-axis
„ Range of displayed angles for angular measurements
To configure display settings:
U Press MENU/SETUP to display the setup menu and then highlight
the Display menu item.
U Highlight the MM and Inch Disp Res data fields and enter the display
resolution index numbers for each unit of measure. For example, an
index number of 0.001 will round the display of MM or inch to 3
digits to the right of the radix character.
U Highlight the DMS Disp Res data field and enter the Degree/
Minutes/Seconds index number. For example, an index number of
0.01 will round the display of 30
° 20’45” to 30 ° 21’.
U Highlight the DD Disp Res data field and enter the Decimal Degrees
index number. For example, an index number of 0.01 will round the
display of 30.786 degrees to 30.79 degrees.
Enter the display resolution index
numbers for linear measurements Enter the display resolution index
number for angular measurements in
Degrees/Minutes/Seconds Enter the display resolution index
number for angular measurements in
Decimal Degrees