HEIDENHAIN ND 760 E - Manual (Page 23)

23
To erase error messages:
After you have removed the cause of error:
➤ Press the CL key.
Error Messages
Message Cause and Effect
SIGNAL X
Encoder signal is too weak,
e.g. when an encoder is
contaminated.
ERR. REF. X The spacing of the reference
marks as defined in P43 is not
the same as the actual spacing.
FRQ. X The input frequency for this
encoder input is too high. This
can occur when the scale is
moved too fast.
ERR. MEMORY
Checksum error: Check the
datum, operating parameters and
compensation values for
multipoint axis error
compensation. If the error recurs,
contact your service agency!
Error
Messages
Bateil1.pm6 21.01.2002, 09:39 23