HEIDENHAIN ND 760 E - Manual (Page 12)

12
Switch-on, Traversing the Reference Marks
ENT...CL
Turn on power (switch located on rear panel). REF
in the status display starts blinking.
Confirm reference traverse mode. REF indicator
stops blinking and stays on. Decimal points blink.
Cross over the reference marks in all axes (in any
sequence). Each axis display becomes active when
its reference mark is crossed over.
0 è 1
ENT
Crossing over the reference marks stores the most recently defined
assignment of display values to axis slide positions for datum points 1
and 2 in nonvolatile memory.
Note that if you choose not to traverse the reference marks (by clearing
the dialog ENT ... CL with the CL key), this relationship will be lost if the
power is interrupted or when the unit is switched off.
Switch-on,
Traversing
the
Reference
M
arks
If you wish to use multipoint axis error compensation, you
must traverse the reference marks (see “Multipoint axis error
compensation”)!
Bateil1.pm6 21.01.2002, 09:39 12