Grass Valley T2 Classic iDDR Workstation Mode SP2 - Manual (Page 32)

T2 ― UserManual(SP2) ― Workstationmode ― 32
Section2― Setup
Monitor & Remote settings
Monitor out
Specify the channel to use for monitor out, and specify if OSD (on-screen
display) is enabled.
Channel
Specify the channel to use for monitor out. Only P1 is available for P1 channel,
while P1 and P2 for P2 channel.
OSD
Enables/Disables the on-screen display.
Show Cur timecode
Check this option to show the current timecode for the on-screen display.
Show Remain timecode
Check this option to show the remaining timecode for the on-screen display.
(See “Playlist Remain TC” below.)
Playlist Remain TC
Specify the display style of the remaining time for the playlist.
• Event ........................... Displays the remaining time of the event (clip/
playlist).
• Total ............................Displays the remaining time of the entire playlist.
Remote protocol Choose a REMOTE protocol from BVW and AMP.