Grass Valley T2 Classic iDDR Workstation Mode SP2 - Manual (Page 22)

T2 ― UserManual(SP2) ― Workstationmode ― 22
Section2― Setup
Hardware settings
Clicking the Config button at the top right corner of the screen displayed in
the Workstation mode, the System settings screen will open.
Modify the settings according to your environment.
Config button
System settings
Hardware settings
Reference
The options you can choose from for the reference input method are
External, Input and Internal.
The sync status is displayed in the boxes below this button.
P1
Displays if the P1 channel is synchronized.
P2
Displays if the P2 channel is synchronized.
Tri-Level HD H-shift
To use the HD tri-level REF signal as the HD REF signal, check this box. Enter a
value to adjust the REF phase. (Available only for External)
BB HD H-shift
To use the SD Black Burst REF signal as the HD REF signal, check this box.
Enter a value to adjust the REF phase. (Available only for External)
BB SD H-shift
To use the SD Black Burst REF signal as the SD REF signal, check this box.
Enter a value to adjust the REF phase. (Available only for External)
Audio reference level Adjusts the audio reference level (Headroom).
Audio Input/Output level Adjusts the audio input/output level.