Grass Valley T2 Classic iDDR - Manual (Page 99)

October 17, 2011 T2 Users Manual –SP3/SP4– 99
Backing up all data to other T2 (Sync backup)
Setting T2 on the sync source (master) to the master mode for
data sync
1. From the menu bar, click System T2 to T2 Sync backup...
• If you capturing or loading clips in the R1/P1/P2 channel, a message appears
asking whether to unload clips. Click OK to unload clips.
• The "T2 to T2 Sync backup" dialog box appears.
2. Select Master mode , and then click Slave configuration...
• T2 on the sync source (master) is set to the master mode.
• The number of T2 set to the slave mode is displayed in "Slave count:".
3. Set the IP address of T2 set to the slave mode.
• Click Auto Search... to search for T2 set to the slave mode on the network.
Select an IP address on the search result dialog box, and then click Add ALL .
• To set an IP address manually, click Add... and enter an IP address.
4. Click Close .