Grass Valley T2 Classic iDDR User Manual
Page 87

October 17, 2011
T2 Users Manual –SP3/SP4–
87
Setting a specific timecode to an event in a playlist
Setting a specific timecode to an event in a playlist
You can set a specific timecode to each event (clip event/playlist event) in a playlist.
In the 1ch mode or trim mode, you can check the timecode set to each event.
The following is the procedure for setting a specific timecode to each event.
NOTE: If you set a specific timecode to a clip, you can retain the timecode setting
at the time when the clip is added to a playlist. After adding a clip to a playlist,
perform the operations of steps 3 and 4. (If you change the timecode setting of the
original clip after adding the clip to a playlist, the setting will not be reflected in the
playlist.
1. Display the event properties.
2. Click the
Timecode
tab and set the timecode of the event
• To use the timecode of the source in a media file, select
Source
.
• To use any given timecode, select
Specify start time
and enter the start
timecode.
• To retain the timecode setting for the event in a playlist event, select
According
to event setting
.
3. Display the playlist properties.