beautypg.com

Grass Valley T2 Classic iDDR User Manual

Page 108

background image

108

T2 Users Manual –SP3/SP4–

October 17, 2011

Chapter 6 Additional/Updated Functions for SP3 and SP4

7. Select "Exit Saving Changes", and then press the [Enter] key on the keyboard.

8. Select [Yes] on the confirmation dialog box, and then press the [Enter] key on the

keyboard.

9. Restart your T2 in the maintenance mode.

• If you use the LAN2 terminal, the Wake On LAN function is enabled. Proceed

to

"Step 2: To check the MAC address/IP address of the NIC" on page 108

.

10. In the

Start

menu, right-click

My Computer

, and then click

Properties

.

11. Click the

Hardware

tab, and then click

Device Manager

.

12. Click the "Network adaptors" tree.

13. Right-click

Intel(R) 82567LM-3 Gigabit Network Connection

, and then click

Properties

.

• The network adapter for the LAN1 terminal is Intel(R) 82567LM-3 Gigabit

Network Connection. The network adapter for the LAN2 terminal is Realtec

RTL 8168C(P)8111(P) PCI-E Gigabit Ethernet NIC.

14. Click the

Advanced

tab, and then change the settings to the following:

(1)Click "Wake on Settings" in "Property:", and then select Wake on Magic Packet

from the "Value:" list.

(2)Click "Enable PME" in "Property:", and then select Enabled from the "Value:" list.

15. Click the

Power Management

tab, and then check

Allow this device to bring the

computer out of standby

.

Step 2: To check the MAC address/IP address of the NIC

1. Restart your T2 in the maintenance mode.

2. Execute ipconfig /all at the command prompt.

3. Check the MAC address, the IP address, and the subnet mask.

Step 3: To turn on your T2 by sending packets from the PC

Send packets from your T2 to the PC using the MAC address, the IP address, and the

subnet mask checked in Step 2.

Turn off your T2 and confirm that the network cable is connected to the LAN1

terminal or the LAN2 terminal beforehand.

1. Send Magic Packet via network.