Grass Valley T2 Classic iDDR - Manual (Page 100)

100 T2 Users Manual –SP3/SP4– October 17, 2011
Chapter 6 Additional/Updated Functions for SP3 and SP4
5. Click Start Sync on the "T2 to T2 Sync backup" dialog box.
6. A message appears. Click OK .
• The synchronization begins. You can check the file transfer status on the upper
progress bar, and the whole status on the lower progress bar.
• If you stop sync, click Stop . You can stop sync from T2 set to the slave mode.
NOTE: If data sync is stopped forcibly such as when the power of T2 goes off etc.,
clips may be displayed with the following thumbnail. Such a clip cannot be used.
NOTE: If synchronization is stopped and started again, already transferred files
will be skipped.