Connection between t2 and a device, Connecting your t2 and p2 drive (aj-pcd20) – Grass Valley T2 Classic iDDR User Manual
Page 36

36
T2 Users Manual –SP3/SP4–
October 17, 2011
Chapter 3 T2 P2 Option
• DVCPRO
○:
Supported
Connection between T2 and a device
Connecting your T2 and P2 drive (AJ-PCD20)
Before performing this procedure, you must prepare the P2 driver for Windows
(32bit) supported by AJ-PCD20 in the OS (C:) drive. For more information about the
software information or installation procedure of the P2 driver, please refer to the
instruction manual of your AJ-PCD20 or the Panasonic Corporation Web site.
1. Start up your system in the maintenance mode.
• For instructions on how to start up your system in the maintenance mode, refer
to the Maintenance Manual of your T2.
2. Connect your AJ-PCD20 and install the P2 driver.
• For more information about the installation procedure of the P2 driver, please
refer to the instruction manual of your AJ-PCD20 or the Panasonic Corporation
Web site.
3. Exit the maintenance mode and restart your system in the normal mode.
CAUTION: Depending on your environment, you may be asked to restart your T2
after completing the P2 driver installation. In this case, you must restart your
system leaving it in the maintenance mode and then switch to the normal mode
(CommandCenter) after your T2 is started.
4. Plug the power cord of your AJ-PCD20.
• Your device is turned on once the power plug, AC adapter, and AJ-PCD20 are
connected. For more information, please refer to the instruction manual of your
AJ-PCD20.
Browse
FTP
Import
Export
List view
Direct
playback
Upload
Download Import Post-import format
Export
Post-export format
○
○
No
No
○
P2
○
P2
MXF (OP-1a)
○
MXF (OP-1a)
Grass Valley HQ
AVI
○
Grass Valley HQ AVI
or
XDCAM (MXF single)