Grass Valley SSP-3801 Installation v.1.3 User Manual
Page 45
41
SSP-3801
Installation and Configuration Guide
To configure the router:
1 Open and log into the SSP-3801 card’s web interface (see
2 From the menu, select Card Configuration > Router Control.
Fig. 4-10: Router Control page
3 In the Type list, select the type of router connected to the card. Click:
• None: to disable Router Control.
• Virtual Router: to enable a virtual test router. The virtual router does not perform
video switches, but allows the card to act as though an actual router is connected
so it can be used to test the behavior. For example, a Source primary event added
to the playlist will act as though it played out and the Log Viewer will be updated,
but no actual video switching is performed.
• CQX Compact Router: to enable control of an NVision Compact CQX router.
• NV9000 Router Controller: to enable control of an
NV9000 router control system.
4 Depending on the type of device selected, the options on the page will differ.
Configure the following as required by the selected type:
Note:
The card only supports ASCII 7-bit printable characters for
mnemonics, the asset IDs, and paths. For more information, see "
About the
supported characters for asset IDs, paths, and mnemonics
" in the SSP-3801
User Guide.