Grass Valley SSP-3801 Installation v.1.3 - Manual (Page 22)

18
Installing the SSP-3801 card
Installing the rear connector panel
Installing the rear connector panel
The SSP-3801 rear connector panel must be installed in the Densité 3 frame before the card
can be inserted.
To install the rear connector panel:
1 If a card is installed in the slot whose rear panel is being changed, remove it or slide it
over by releasing the captive screw(s) at the bottom and then moving or removing the
card.
2 Position the SSP-3801 rear connector panel with the connectors facing outwards and
the captive screws at the bottom.
3 Secure the rear connector panel in place by tightening the captive screws at the
bottom.
Figure 3-1. SSP-3801 rear connector panels installed in a Densité 3 frame
Installing the SSP-3801 card
Once a matching rear connector panel has been installed, you can install the SSP-3801 card.
Note: All Densité 3 cards and rear panels can be installed with the
frame power on. As a safety precaution however, we
recommend turning off power to the
Densité 3 frame during
the installation of the rear connector panel.