Cabling the ssp-3801 card, Starting the ssp-3801 card – Grass Valley SSP-3801 Installation v.1.3 User Manual
Page 24
20
Installing the SSP-3801 card
Cabling the SSP-3801 card
Cabling the SSP-3801 card
Cabling the SSP-3801 depends upon your intended use. Note that the scope of this
document is limited to setting up the SSP-3801 card for basic start-up functionality. As
such, you should ensure that the following connections are made to the rear connector
panel of the SSP-3801 card.
• Connect a network Ethernet cable to the ETH1 Ethernet port. Note that the default
configuration is to provide redundant bonded networking with ETH1 as primary and
ETH2 for redundancy.
• Connect the
PGM
(SDI Output) to downstream equipment such as a broadcast monitor
or a router input, for example.
• Optional - Connect an external reference source to
REF IN
• Optional - Connect HD/SD SDI source input to
A (SDI IN A)
Information about the remaining input-output connections are provided on
Figure 3-3. Basic SSP-3801cabling connections
Starting the SSP-3801 card
Once the SSP-3801 rear connector panel and card have been installed, power up the
Densité 3 frame and ensure that the card is running properly.
PGM SDI
Output
A SDI Input
(optional)
Ethernet
Port ETH1
REF IN
(optional)