beautypg.com

Grass Valley RCP-10x0 User Manual

Page 28

background image

GUIDE TO INSTALLATION AND OPERATION

24 | RCP-10x0

5.2 Panel

configuration


1. From the computer, open a console (Start – Programs – Accessories – Command Prompt)

and type “arp –d”:

This clears the ARP table and makes sure no MAC address is linked to the IP address of the panel.


2. Open Internet Explorer on the PC and type “http://192.168.100.100/” in the Address window. You should

get the setup page of the panel. Depending on the version of your panel, it should look something like
this:


3. In

the

Ethernet Interface section, enter the IP parameters for the panel that will be used when the panel

is put in OPERATION mode. If you are using DHCP mode, the Fixed Values are not normally used, but
they will be used if a DHCP server is not available. If you use fixed parameters and want to specify a