beautypg.com

Grass Valley RCP-10x0 User Manual

Page 12

background image

GUIDE TO INSTALLATION AND OPERATION

8 | RCP-10x0

Bus number (1-4) – enter the following data, depending on the mode selected in the pulldown

• Single bus mode – the number of the bus that is to be controlled
• Dual bus mode – enter the number of the first bus to be controlled (possible values 1, 2 or 3)

o

the RCP-10x0 will control that bus and the next one

• The default value is 1

3.4.2 Ethernet

Interface


Select the IP addressing mode using the pulldown.


The available choices are:

DHCP

use dynamic network addressing. When selected, it allows a server to dynamically attribute an IP
address and configuration information to the RCP-10x0. Normally the DHCP server provides at least
the following basic information: IP address, subnet mask and default gateway. When "DHCP" is
chosen, the fixed network parameters are not used unless a DHCP server cannot be found. DNS
servers are usually also reported by the DHCP server (2 are reported but only the primary server is
displayed in the web page)

Fixed

forces the RCP-10x0 to use the attributes entered in the Fixed IP Mode data boxes. The user should
consult the network manager if unfamiliar with the requirements for this data.

o

Enter data for the four listed Fixed IP Mode network parameters


The MAC address is a unique identifier for this specific device, and is not user-configurable.

3.4.3 Densité

Chassis


Enter the information that identifies the router that the RCP-10x0 will control.