Grass Valley RCP-10x0 - Manual (Page 22)

GUIDE TO INSTALLATION AND OPERATION
18 | RCP-10x0
4.6.2 TAKE Button
The TAKE button has two applications:
1. PRESET – TAKE
When the panel is in XY-With Preset mode, selecting a destination and a new source will NOT
activate the crosspoint. Instead:
• The new source button and the TAKE button will flash together
• Pushing the TAKE button will activate the crosspoint
• The pending TAKE will time-out after 30 seconds, and the TAKE and source buttons will
stop flashing
2. Salvo Firing
When the RCP-10x0 is in any state except {XY With Preset and a pending TAKE}, the TAKE button
is used to enable the Salvo Firing mode.
The HRS-1801 can be programmed with up to 10 Salvos (i.e. presets). These salvos cannot be set
from the RCP-10x0, but they can be fired.
• Push and hold the TAKE button, and all buttons except the rightmost ten buttons in the top
row of source buttons, plus the ENABLE and TAKE buttons, will be extinguished.
• The ten source buttons will be amber at low intensity
• The ten source buttons control the ten Salvos, counting from left to right.
• Push the appropriate source button to fire the salvo
• Release the TAKE button to view the normal button display
Note that if you disable the TAKE button in the Setup panel, and place the RCP-10x0 in XY with Preset
mode, the panel will function as a Read-only panel
• The source buttons will display the crosspoint status by color, and show which is selected for each
destination by intensity, but the crosspoints cannot be activated by pushing the buttons.
Green
Red Colors
Amber
This button is always amber.
Off
The panel is in XY-without preset, single, dual or quad bus
mode, button is unused or panel is disabled.
Low
Panel is in XY –With Preset mode. Selecting a source only
presets this source.
Intensities
High
A TAKE operation is pending. If the take operation is not
completed after a 30 second timeout, the preset will be
cleared and intensity of this button will return to LOW.
None Normal operation
Slow A TAKE operation is pending. Used with “High”
TAKE
button
Flashing
Fast Unused