Grass Valley RCP-10x0 - Manual (Page 18)

GUIDE TO INSTALLATION AND OPERATION
14 | RCP-10x0
4.1 Operating Modes
The panel may be configured in any of the following operating modes:
RCP-1010 RCP-1020 RCP-1030 RCP-1040
Single Bus Single Bus Single Bus Single Bus
XY – Without Preset Dual 10x1 Bus XY – Without Preset Dual 20x1 bus
XY – With Preset XY – Without Preset XY – With Preset Quad 10x1 bus
XY – With Preset XY – Without Preset
XY – With Preset
4.1.1 XY without preset mode
• Operates as an Nx4 router, with N being the number of sources supported (e.g. RCP-1020 supports
20 sources)
• Select the destination, then push the source button to activate the crosspoint
4.1.2 XY- with preset mode
• Operates as an Nx4 router, with N being the number of sources supported (e.g. RCP-1040 supports
40 sources)
• Select the destination, then push the source button to preset a switch
• Push TAKE to activate the crosspoint
4.1.3 Single Bus mode
• The destination bus is pre-selected in the configuration and the panel operates only that bus on the
router
• Push the source button to activate the crosspoint
4.1.4 Dual Bus mode
• The panel is configured to control two consecutive destination buses on the router (e.g. 1 & 2, 2 & 3
or 3 & 4)
• The upper row of source buttons is assigned to the first controlled bus
• The lower row of source buttons is assigned to the second controlled bus
• The source buttons are assigned to M consecutive sources, where M is the scale of the Dual Bus
mode (e.g. 20x1 can control 20 consecutive sources)
• The first controlled source is specified in the configuration.
• Push the source button to activate the crosspoint
4.1.5 Quad Bus Mode
• The panel is configured to control all four output busses of the router (only available with RCP-1040)
• The panel source buttons are assigned to the buses in groups of 10, each being half of the upper or
lower row