Grass Valley RCP-10x0 - Manual (Page 11)

GUIDE TO INSTALLATION AND OPERATION
RCP-10x0 | 7
Functionality:
• In CONFIG mode, the panel cannot be used to operate a
router
• In OPERATE mode, the panel is functional and can control a
router
Enter the IP address of the router in your browser’s Address window to
open the web page generated by the RCP-10x0’s on-board web
server.
Click on the Setup tab to open the configuration window.
The window is shown on the right, and includes a number of distinct
sections, which will be discussed individually
3.4.1 Panel Mode
Select the panel operating mode using the Panel Mode pulldown.
The available options are shown in the table below, and will be discussed in detail in section 4.
RCP-1010 RCP-1020 RCP-1030 RCP-1040
Single Bus Single Bus Single Bus Single Bus
XY – Without Preset Dual 10x1 Bus XY – Without Preset Dual 20x1 bus
XY – With Preset XY – Without Preset XY – With Preset Quad 10x1 bus
XY – With Preset XY – Without Preset
XY – With Preset