Grass Valley Maestro Master Control Reference Manual v.2.4.0 - Manual (Page 82)

82 MAESTRO — Automation Interface Protocol Technical Reference Manual
Section 4 — Definition of Supported Saturn Commands
TRAN_PRESET (Preset distributed transition parameters)
This command allows all of Saturn's distributed transition parameters to be preset directly.
Hex definition Mnemonic
E3 TRAN_PRESET
Command format:
TRAN_PRESET
Query format:
READ TRAN_PRESET
Reply format:
IFRE TRAN_PRESET
Note: The response will contain a reply for each board requested in the argument of the query, wrapped
within a begin-end construct.
Use applicable with UPDATE:
Yes
Argument definitions:
<
board bits> = 00-0F(hex, one byte)
Specifies the Saturn board affected by the command.
bit 7 - bit 4 = reserved
bit 3 = Audio 5/6 board (Mode 2-CH5 Mono, Mode 1-CH5/6 Stereo)
bit 2 = Audio 3/4 board (Mode 3-CH3 & CH4 Mono, Mode 1,2-CH3/4 Stereo)
bit 1 = Audio 1/2 board (All Modes-CH1/2 Stereo)
bit 0 = Video board
<type> = 0, 1-4
Specifies the transition type, or reports the current transition type on a reply.
0 = Transition type NOP
1 = Cross-fade
2 = Fade-cut
3 = Cut-fade
4 = Fade-fade
<rate> = 0, 1-5
Specifies the transition rate, or reports the current transition rate on a reply.
0 = Transition rate NOP
1 = Slow
2 = Medium
3 = Fast
4 = Cut