Grass Valley Kayenne XL Package Installation v.7.0.4 - Manual (Page 160)

160 Kayenne XL Package — Installation and Service Manual
Section 5 — Maintenance
• Select the Advanced menu select IDE Configuration
• Set Legacy IDE Channels to PATA Only
• Select the Advanced menu select USB Configuration
• Set USB Mouse Legacy Support to Enabled.
• Select the Boot menu and set
• 1st Boot Device to Primary Master
• 2nd Boot Device to Secondary Master
• 3rd Boot Device to USB Harddisk
• Quiet Boot to Enabled
• Halt On Errors to Disabled
• Press the F10 Key and then press Enter to select Yes and save the new
CMOS settings
Menu Processor
• Connect a computer keyboard to the PS2 connector on the Menu Pro-
cessor and a computer monitor VGA plug to the VGA socket.
• Press and hold Del key immediately while booting the switcher to
display the BIOS-menu.
• Load the CMOS Default in the Exit menu.
• Select the Main menu and check / set the System Time and Date.
• Select the Advanced menu select Graphics Configuration
• Set Local Flat Panel Type to Customized EDID 1
• Select the Advanced menu select Chipset Configuration
• Set POST Code Output to LPC
• Select the Advanced menu select I/O Interface Configuration
• Set Onboard Audio Controller to Disabled
• Select SIO Winbond W83627 Configuration