Grass Valley Kayenne XL Package Installation v.7.0.4 - Manual (Page 100)

100 Kayenne XL Package — Installation and Service Manual
Section 4 — System Cabling
• Pressing Modify opens a pop-up window with the functions that can be
programmed.
• -- -- -- no function
• 2nd this button is used as 2nd button i.e. shifts the source selection
buttons
• 3rd this button is used as 3rd button i.e. shifts the source selection
buttons
• AUX n, P/P Bus, M/E Bus, 
these buttons delegate the AUX-CP to crosspoint selection for the
given bus.
• Ext. AUX n - this button delegates the AUX-CP to crosspoint selection
for the given external aux bus.
• TiM/E Memo n - this button delegates the AUX-CP to register recall
for the given TiM/E Memo system.
• Ram Rec - this button delegates the AUX-CP to the RamRecorder.
• Router - this button delegates the AUX-CP to the Router.
• eDPM - this button delegates the AUX-CP to the eDPM.
Note At least one function other than -- -- --, 2nd or 3rd must be programmed.
Otherwise the AUX-CP performs no action at all.

Since the CP-3020 Aux control panel module has only two delegation but-
tons,
Deleg 1 and Deleg 2 may be programmed with 2nd and 3rd . In this
case, Deleg 3 defines the function of the AUX-CP. Deleg 4..6 can be
ignored.
• Assign

There are three modes:
• When the AUX CP is used for crosspoint selection of internal
busses, the sources can be assigned freely to the source selection
buttons of the AUX CP.
To do this, Assign changes the contents of the index card.
• Using for crosspoint selection of external AUX busses.
The procedure for input assignment is very similar to the input assignment
for the control panel. Please refer the User Manual for further details.