Grass Valley K2 Summit Client Upgrade Instructions v.8.x Mar.02 2012 - Manual (Page 31)

5. Repeat the process for the second Fibre Channel Controller as follows:
a) Right-click on the remaining Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
6. Verify that the two "ATTO" devices are now listed under the SCSI and RAID Controllers
7. Close the Device Manager and System windows
Next, install the SiteConfig Discovery Agent.
Installing the Discovery Agent on a K2 Summit system
Do this task for all (V8x, CPU, 3G1, 3G2) upgrade kits.
Before doing this task, make sure the write filter is disabled.
Find the Discovery Agent installation files on the USB Recovery Flash Drive you received with the
upgrade kit. The files are in the
ConnectivityKit folder.
1. Navigate to your SiteConfig files.
2. To launch the program that installs the ProductFrame Discovery Agent Service do the following:
a) Copy the Discovery Agent Setup subdirectory to the device.
b) In the Discovery Agent Setup directory, double-click the
DiscoveryAgentServiceSetup.msi file.
The setup program launches to install the SiteConfig Discovery Agent.
c) Follow the setup wizard.
3. When presented with a list of device types, select one of the following as appropriate:
• K2SummitSanClient
• K2SummitStandaloneClient
4. Complete the setup wizard and restart the device.
The restart is required after the installation.
Next, restore licensing.
Related Links
Disable write filter on page 36
02 February 2012 K2 Summit/Solo Field Kit Upgrade Instructions 31
Upgrade instructions