Grass Valley K2 Summit Client Upgrade Instructions v.8.x Mar.02 2012 - Manual (Page 30)

5. If the K2 Summit system has a dual port Fibre Channel card, on the Found New Hardware wizard,
install the driver on the second LSI Pseudo Device port as follows:
a) Select Install from a list or specific location and then click Next .
b) Select Don’t search. I will choose the driver to install and then click Next .
c) Select Have Disk .
d) Browse to C:\Windows and find LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e) Start the driver install by selecting Next .
f) On the Hardware Installation page, click Continue Anyway .
g) Click Finish .
6. If the K2 Summit system is on a redundant K2 SAN or is connected to direct-connect storage,
make the following registry settings:
[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Symmpi\Parameters\Device]
"DriverParameter"="MPIOMode=2"
"MaximumSGList"=dword:000000ff
"NumberOfRequests"=dword:00000020
Next, install the SiteConfig Discovery Agent.
Installing the ATTO Fibre Channel card driver
1. Open Device Manager.
2. Right-click on K2 Summit Client and select Manage.
3. Click Device Manager
4. Install the first Fibre Channel driver as follows:
a) Right click on the upper Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
h) In the Found new hardware wizard that will open for the ATTO Phantom device, select No,
not this time .
i) Select Install from a list or specific location and then click Next .
j) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
k) Click OK .
l) Click Next. .
m) Click Finish when prompted.
30 K2 Summit/Solo Field Kit Upgrade Instructions 02 February 2012
Upgrade instructions