Grass Valley LDK 5417 - Manual (Page 55)

LDK 5417 + LDK 4417 User’s Guide | DC/DC converters 43
11.1 Installation
To attach the DC/DC convertor to the camera proceed as follows:
• Ensure power is disconnected.
• Attach the LDK6506 fixing plate to the tripod plate using the supplied bolted screws
(A).
• To ensure the converter’s thermal isolation from the tripod attach the screws in the
exact following order:
1. Tighten screw (B).
2. Tighten two screws (C).
• Connect the cable from the DC IN input of the converter to the DC OUT output of the
camera. This cable is supplied with the converter.
• Connect the equipment to be supplied to the "DC OUT 12V/50W" or "DC OUT 24V/
50W"ouput depending on the converter type used.
Figure 1-15. Installing the DC/DC converter
☞
Note
The LDK 6506 Fixing Plate is always required when using the LDK5930/5940 DC/DC
convertor with LDK cameras.
Screws C
Screw B
DC/DC convertor Tripod plate
LDK 6506 Fixing plate *
Screws A